Follow the directions in your owners manual when tightening the belt. To check if the belt is too tight, lift it in the center. Belts can slip when there’s too much friction or if the belt is over-tightened. To fix treadmill problems associated with slippage, align and tighten the running belt. Continue to loosen or tighten the belt as needed. 7 Reasons Your ProForm Treadmill Might Not Be Working and How to Troubleshoot It. If you feel a slipping sensation when using your treadmill, it may be in need of minor treadmill repair. You must loosen both bolts or the belt will come off center. Insert the Allen wrench in the left roller bolt and turn it one-quarter of an inch to the left, and repeat the process on the right roller bolt if the belt is too tight. You should have approximately two inches of space between your fingers and the platform. Remove the safety key from the treadmill and unplug the power cord. Place your fingers under the belt and lift up. Tighten the belt by placing the Allen wrench in the left roller bolt and turning it to the right one -uarter of a turn, and repeat the process with the right roller bolt. If everything is alright, put the motor hood back. To center the belt, increase the speed and use the left side adjustment bolt to fix the position. ![]() If it needs adjustment, turn the left and right adjustment bolts. Insert the Allen wrench in the left roller bolt and turn it one-quarter of an inch to the left, and repeat the process on the right roller bolt if the belt is too tight. Start the treadmill at a speed of 2 mph: walk a few steps to check the belt doesnt slip. Remove the safety key from the treadmill and unplug the power cord. Repeat Steps 1 through 5 until the belt is centered on the treadmill. Treadmill Maintenance If you wish for your treadmill to remain in good condition, ensure that you take proper care of it. Plug the power cord into the electrical outlet, insert the safety key and run the treadmill for several minutes to ensure that the belt is centered. Proform space saver treadmill belt slipping. Turn the left roller bolt one half turn to the right if the belt has shifted to the left, and turn the right roller bolt one half turn to the left if the belt has shifted to the right. The roller bolts are located on the back of the treadmill to the left and right of the belt. Place the Allen wrench in the left rear roller bolt if the belt has moved to the left, and in the right rear roller bolt if the belt has moved to the right.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |